How we verify fit data
Every number on a saw page comes from a published document, and the page shows which one. This page explains the labels you see next to the numbers and the rules behind them.
Where the numbers come from
Documents are sorted into four groups, and the group decides how much weight a document carries.
- The saw maker’s own documents: operator’s manuals, product pages, parts lists and the maker’s chain selection guides.
- A chain or bar maker’s fit data: for example a chain maker’s selector guide that lists the saw by model.
- Dealer and retailer listings of the maker’s own part. Useful as a second document for a part number, never enough alone.
- Everything else: marketplace sellers, forums and other fit sites. These are recorded when they disagree with the makers, but they never decide a number.
What the labels mean
- Verified: two or more separate documents agree, and at least one of them comes from a manufacturer. Marketplace listings, forums and other fit sites are never counted, and two editions of the same manual count as one document.
- One source: a single manufacturer document gives the number and no second document was found.
- Sources disagree: manufacturer documents give different numbers and nothing explains the difference. The page shows each number and who gives it, and does not pick one.
- Unconfirmed: only seller listings or similar pages support the number.
The label is not typed in by hand. Software works it out from the list of documents behind each number and refuses a page whose label claims more than its documents support.
When documents disagree
The first question is whether both can be right. Many disagreements turn out to be versions of the same saw: a change of bar gauge between production years, a different sprocket, a bar length sold only in some markets. Those are shown as separate rows with a note on how to tell which version you have.
If two manufacturer documents still disagree, the row is marked as a disagreement and gets no shopping link. If a seller’s page disagrees with the maker’s document, the maker’s number is used and the other number is listed under “Numbers you may see elsewhere” with the reason. Disagreements are never settled by counting how many listings say what.
Evidence you can check
Under each row, “Show the evidence” lists the words in each document that support the number, with the page or section they come from. The numbered sources at the foot of the page link to the documents themselves.
Equivalent chains
A chain from another maker is called an equivalent only when that maker lists the saw. A chain that merely has the same pitch, gauge and link count is labelled as having the same specification, which is a weaker statement.
Who does the work
Research and first drafts are produced with an AI assistant. A person, the site’s publisher, approves each page before it is published, and a page that has been approved shows when. Nobody at FitsMySaw tests or measures the saws; the site reports what the documents say.
Keeping it current
Each page shows the date its data was last verified. That date changes only when the numbers were actually checked again, not when the page is edited for other reasons.
The limits of this method
Manufacturer documents can contain mistakes, and the bar on your saw may not be the one it left the factory with. Before ordering, read the numbers stamped on your bar and compare them with the page. If they differ, go by the bar. How to find the numbers on your own saw.